TABLE TOP SOLUTIONS
3
•
Do not place heavy objects on top of the
Tilt ‘N Plug Jr.™
. Do not use excessive
force to push down on the top of the unit.
•
To turn off the main power, disconnect the
power cord, which powers the power socket
on the
Tilt ‘N Plug Jr.™
pop up panel only.
The power outlet used should be installed
as near to the equipment as possible and
should be easily accessible.
•
We recommend using wall outlets with a
Ground Fault Circuit Interrupter (GFCI) for
maximum protection.
•
Install all cables according to the
instructions. Do not force or pull out any
cable or power cord that is attached to the
Tilt ‘N Plug Jr.™
Interconnect Box.
1.3 CLEANING
•
Surfaces should be cleaned with a dry cloth.
Never use strong detergents or solvents,
such as alcohol or thinner. Do not use a wet
cloth or water to clean the unit.
1.4 FCC / CE NOTICE
•
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and (2)
this device must accept any interference
received, including interference that may
cause undesired operation.
•
This equipment has been tested and found
to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference when the equipment is
operated in a commercial environment. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instruction
manual, may cause harmful interference to
radio communications. Operation of this
equipment in a residential area is likely to
cause harmful interference in which case
the user will be required to correct the
interference at his own expense.
•
Any changes or modifications to the unit not
expressly approved by ALTINEX, Inc. could
void the user’s authority to operate the
equipment.
ABOUT YOUR Tilt 'N Plug Jr.™
2
Tilt 'N Plug Jr. ™
's are members of a family of
compact interconnection solutions designed for
installation into a table in a presentation system.
These products are designed for mounting into a
table, podium, or other furniture to provide a way of
connecting audio/visual equipment on top of the
furniture to a presentation system below the furniture.
All use the same core element; a multimedia input
plate that can be "tilted" open when needed and
pushed closed when not needed.
The
TNP122/142/ 152/162
incorporates two
Tilt ‘N
Plug Jr.™
individual tower modules, the
TNP123
incorporates three individual modules and the
TNP124
incorporates four individual modules. Each
module can be operated independently; the
TNP124/152
can service from one to four users
simultaneously. During installation of the
TNP122/123/152/162,
the individual tower modules
can be reversed to face opposite directions through a
simple field-modification to the bezel. This alternative
configuration is handy for applications in which the
TNP122/123/152/162
needs to service two sides of a
table simultaneously. Note that the
TNP142
is the
same as a
TNP122
but with the modules factory-
installed facing in opposite directions.
The
TNP131
is the same as a
TNP121
but with a
round bezel instead of square. The
TNP162
is a dual
module configuration with a
TNP121
module and a
TNP151
module side by side. The
TNP124
is a quad
TNP121
with two rows of twin modules facing in
opposite directions; the modules in the
TNP124
cannot be reversed.
The
TNP421/431/441/451
are international models
with power connectors for specific countries. The
TNP421
has a standard "Schuko" receptacle for
