Altinex Tilt `N Plug Interconnect Box TNP100UK, Руководство пользователя, Страница: 10 / 13

ACCESSORIES
9
INSTALLATION 6
Step 1 . Cut an opening into the table’s surface.
Refer to diagram 5 on page 8 of the
manual for table cutout requirements.
Note: The table can be 3 inches or thinner
in thickness. Always confirm dimensions
before cutting to ensure that specifications
have not changed.
Step 2 . Insert the TNP100UK into the opening in
the table.
Step 3 . Place the support brackets under the table
and place them between the support
mount grooves on the side of the
TNP100UK unit. Attach the brackets to the
groove at the desired height and secure
them to the bottom of the table using the 6-
32 screw. There are two support brackets,
one for each side of the unit. (See Figure
1)
Figure 1: Attachment of the TNP100UK
to a table using support brackets and set
screws
Step 4 . Secure the cables by using the provided
cable clamp (See Figure 2). Pass the
power cord from the bottom of the housing
and attach it to the table using the cable
clamp supplied with the
TNP100UK unit.
Do not keep the cord too tight or too loose
(See Diagram 4, page 7).
Figure 2: Cable Clamp
Step 5 .Connect the appropriate cables with the
correct input connectors. There are two
RCA audio connectors on the front panel
of the
TNP100UK . The black connector is
known as audio left, whereas the red
connector is called audio right. There is
also an RCA video connector, which is
yellow in color. In addition, the network
connection is red.
Step 6 . Once you have applied power and
connected the proper cables on the bottom
of the unit, you may raise the unit. To raise
the
TNP100UK into position, lift the top by
pulling upward at the notch in the top plate.
Step 7 . To lower the unit, push on the top of the
TNP100UK until it fits into place.
For more information, please refer to the FAQ
Section or the Troubleshooting Guide.