MU400-111
User’s Guide
400-0572-008
11
Recommended Components
7. Operation
The MU400-111 Transmitter requires no adjustments for performance. Once set-up, the MU400-111 Transmitter will work
trouble-free without user intervention. For technical support please call 1-800-ALTINEX(258-4639).
There are few things that need to be done right to assure trouble-free operation:
1.
Assure that the correct cable and connector are used. Use the recommended cable and connectors as they were tested
with the MUSE products. Patch cables should not be used with the MUSE because they do not have the current capacity
to provide sufficient power to a display. Also, patch cables attenuate HDMI signal and therefore will result in unreliable
video.
2.
Terminate RJ45 connectors using proper tools. Many plastic termination tools do not have the strength to make good
termination. Use the recommended tools to avoid damaging MUSE RJ-45 connectors. In our experience, the most
damage occurs when connectors are not properly terminated.
3.
Use only as much cable as needed to get from a source to display. Do not coil and leave extra cable “just in case”. Every
foot of cable takes little bit of power away from the receiver (Typically 5W per 25ft of cable). Making the cable as short
as possible maximizes the power available to the display.
4.
Understand your monitor power consumption. Most monitors 42”-50” screen size can be powered by MUSE. There are
however some exceptions for monitors that have very large initial current requirements. These are typically Plasma
displays or low cost, non-Energy Star compliant displays. If you have difficulty powering up a display, adjust the settings
to Eco mode (which will maximize power consumption).
5.
The MUSE can power multiple displays and other equipment. The only limitation is the initial startup current value.
This can be minimized by turning each display ON separately about 5-10 seconds apart.
6.
Many monitors have a built in audio amplifier. This amplifier can consume a lot of power when set to maximum
volume. Make sure to adjust the volume to the level that will actually be used. It is not unusual for an audio amplifier to
consume 20-50W of peak power and be listed at 15W RMS power.
7.
In addition to displays, the MUSE products can power any other equipment compatible with 120V outputs. This
includes lights, small motors, computers, laptops and many more accessories. Since these accessories have a smaller
initial current (compared to monitors), it will be possible to load the output of the MUSE to its limit.
8.
To fully understand your monitor profile, it is advisable to purchase a low cost Watt meter that will display the power
consumption of a display. This will eliminate the hassle of trial and error when selecting the right monitor.
Supplier
Designator
Part Number
Description
Supplier Website
Firefold
Crimp tool
100004C
Modular Crimping Tool
RJ45 Connector
CAT6-RJ45-23AWG-
SOL
RJ45 Connector
CAT6 cable
1 KCMR-BLU
CAT 6 cable
CAT6 cable
CAT6-1KSOL-BLU
CAT 6 cable
Teldor
CAT6 cable
750AZ04129
CAT 6 cable
