6x2 4K Presentation Switcher with Matrix Outputs
Altimium
www.altimium.com
3.2 Rear Panel
①
INPUT: 3 HDMI, 1 DP and 2 VGA with auxiliary audio inputs.
②
OUTPUT:
1-HDMI: HDMI video output port.
2-HDBT: Supports 48V PoH. Connect with a compatible HDBaseT receiver to
transmit AV signal, IR or RS232 control signal.
③
AUDIO INPUT:
LINE: 3-pin phoenix connector for connecting connect with wireless microphone
or line audio input source.
MIC: 3-pin phoenix connector for connecting condenser or dynamic microphone
input
48V phantom power mode switch: When put this switch in “ON” position, the MIC
port for connecting condenser microphone. When put this switch in “OFF”
position, the MIC port for connecting dynamic microphone.
④
AUDIO OUTPUT:
AUDIO 1: 3-pin phoenix connector for analog audio output.
AUDIO 2: 3-pin phoenix connector for analog audio output.
AUDIO 3: Including the below three ports to simultaneously output same audio.
1) 5-pin phoenix connector for balanced/unbalanced analog audio output.
2) 3.5mm mini jack for stereo analog audio output.
3) SPDIF for digital optical audio output.
⑤
CONTROL
Amplifier Output Mode Selector: Stereo, mono or bridge.
EDID: 4-pin DIP switch for invoking embedded EDID.
FIRMWARE: Micro-USB port for updating system firmware.
IR IN: Connect with the IR receiver (with carrier wave only) to control this switcher
via the including IR remote.
RS232: Serial port, 3-pin phoenix connector, connect with a control device (such
as PC) to control the switcher or other third-party device connected with
HDBaseT receiver.
TCP/IP: Ethernet port, connect with PC to control the switcher via GUI.
3
AUDIO INPUT
4
5
AUDIO OUTPUT
L R
CONTROL
SPDIF
1x40W@8
Ω
MONO
DIP
D ef aul t
L R
L R L R
Tx Rx
O n
1
48V
ON OFF
MIC
AUDIO 1 AUDIO 2
O ff
0
1 2 3 4
1 2 3 4
EDID
STEREO BRIDGE
2x20W@4
Ω
LINE
AUDIO 3
FIRMWARE IR IN
RS232
TCP/IP
3-HDMI
1-HDMI
2-HDMI
4-DP
5-VGA
AUDIO
6-VGA
AUDIO
1-HDMI
2-HDBT
INPUT
OUTPUT
AMPLIFIER
1
2
6
7
8
