Note:
Operation tools PC configurator, VisualM and IP controller take
priority over the link DIP switch. Link relationship between encoder
and decoder performed by the DIP switch can be changed using
any other tools.
When audio, video together with IR, and USB signals are routed
via PC configurator, VisualM and IP controller, press and hold the
rear panel RESET button in decoder for less than five seconds to
remove the current link relationship between encoder and decoder,
reverting to the link relationship set by the link DIP switch.
When audio, video together with IR, and USB signals are routed
separately via IP controller's API commands, they can be routed
as a whole with other operation tools.
Using DIP Switch to Perform Routing
Before using the DIP switch, check that routing operations were
not performed by other the tools. Otherwise, the switch function is
disabled. If so, press and hold the rear panel RESET button in
decoder for less than five seconds to enable the DIP switch.
To route the video from source to display, toggle each individual
switches of the front panel DIP switch in decoder to the same
positions as these in encoder. If you want to link the decoder to a
different encoder, change the decoder switch settings in the same
way as how the encoder's switch is positioned. If you want to
remove their link relationship, reset decoder to its factory defaults.
