HDMI/IR/RS232 Twisted Pair Extender
Altimium 2 www.altimium.com
2. Product Appearance
2.1. Appearance of EXT.HDMI70IRSET
ON
LINK
IN
5V
Tx
Rx
HDMI IN
HDBT OUT
RS232
IR IN
IR OUT
1)
ON/LINK/IN LED Indicators: All are green LED.
ON: Working status indicator of this device. When the device works fine, the LED
will keep blinking. And it will turn off when the device stops working.
LINK: Twisted Pair Link status indicator, green LED. It will keep on when
connection is successful.
IN: When connected with devices support HDCP and work normally this green
LED will keep on. If devices not support HDCP, the LED will blink.
2)
POWER LED: Red LED indicator of power. It will keep on when power on.
3)
HDBT OUT: Connects to HDBT IN port in the EXT.HDMI70IRSER via single
CAT5e/CAT6 cable.
4)
HDMI IN: Connect to HDMI source device.
5)
IR IN: Connect with IR receiver, receive IR signals sent from the
EXT.HDMI70IRSER only.
6)
IR OUT: Connect with IR emitter, the sending IR signal are received by the
EXT.HDMI70IRSER.
7)
RS232: Serial port, 3-pin captive screw connector, connects with the control
terminal to control the controlled terminal, supports bi-directional RS232 control
between the EXT.HDMI70IRSET and the EXT.HDMI70IRSER.
8)
5V DC: Connect with DC 5V power adapter.
Note:
Pictures shown in this manual are for reference only, different model and
specifications are subject to real product.
