Altherma EKRTETS, Руководство по установке

Страница: 13 / 26

EKRTR + EKRTETS
Room thermostat
4PW45518-1B Installation manual
11
6 Put the cable bracket back into place and tighten the screws.
7 Close the receiver cover and tighten the screws.
Receiver-thermostat radio configuration
You need to configure the radio connection between the receiver
and the thermostat in order to make communication possible.
1 Put the receiver in radio configuration mode by pressing
è
during 4 seconds.
The
!
LED lights up green and the receiver is now waiting for
a thermostat configuration address.
If needed, you can simply exit this mode by pressing
è
again.
2 Send the configuration address by going to code
5® 03
(
®ƒ ‡≈î‹
)
in the installer menu on the thermostat.
Refer to
“Setting up codes in the installer menu” on page 14 .
The thermostat will now send radio signals. On the LCD the
icon
j
flashes.
3 Verify that the radio signals are correctly received by the
receiver.
If the configuration is OK, the
!
LED blinks green at each
radio signal received from the thermostat.
This also means that the receiver has left the radio
configuration mode.
4 On the thermostat, exit the installer menu by pressing
>
till
the "
/
" code is displayed and then pressing
=
.
5 Verify if the receiver is in thermostat mode and not in manual
mode by checking if the
è
LED is off.
Refer to "LED overview" on page 12 .
Make sure to protect the power supply with a fuse of
3 A.
Select the power cable in accordance with relevant
local and national regulations.
A main switch or other means for disconnection,
having a contact separation in all poles, must be
incorporated in the fixed wiring in accordance with
relevant local and national legislation.