Altera Cyclone IV, Руководство по эксплуатации устройства, Страница: 86 / 490

5–24 Chapter 5: Clock Networks and PLLs in Cyclone IV Devices
Clock Feedback Modes
Cyclone IV Device Handbook, October 2012 Altera Corporation
Volume 1
No Compensation Mode
In no compensation mode, the PLL does not compensate for any clock networks. This
provides better jitter performance because clock feedback into the PFD does not pass
through as much circuitry. Both the PLL internal and external clock outputs are phase
shifted with respect to the PLL clock input.
Figure 5–13 shows a waveform example of the phase relationship of the PLL clock in
this mode.
Normal Mode
An internal clock in normal mode is phase-aligned to the input clock pin. The external
clock output pin has a phase delay relative to the clock input pin if connected in this
mode. The Quartus II software timing analyzer reports any phase difference between
the two. In normal mode, the PLL fully compensates the delay introduced by the
GCLK network.
Figure 5–13. Phase Relationship Between PLL Clocks in No Compensation Mode
Notes to Figure 5–13 :
(1) Internal clocks fed by the PLL are phase
-
aligned to each other.
(2) The PLL clock outputs can lead or lag the PLL input clocks.
PLL Reference
Clock at the Inp
u t Pin
PLL Clock at the
Register Clock Port
(1), (2)
External PLL Clock
O
u tp u ts (2)
Phase Aligned