Altech DT7101, Инструкция по эксплуатации

Страница: 5 / 28

- 5 -
Quick Start Guide
Insert supplied batteries in the remote
control.
1.
With the receiver unplugged, connect the
antenna directly to the ANT input (page 8).
2.
Connect the receiver and the TV using
a antenna cable. This cable allows you to
receive local analogue channels on your TV .
3.
Connect your TV to the receiver with
an HDMI cable, switch the TV to HDMI
mode. (check your TV instruction manual if
necessary ).
4. Connect the power supply to the mains.
Turn the set top on at the rear panel and a
small green light will appear on the front
panel when the unit is ON..
At initial boot the set top will prompt “Do
you want to scan”.
Select Yes and press OK to start auto scan.
Select No should you wish to change
parameters in the set top.
The automatic channels search will start.
The first channel will show on the TV screen
once installation is completed.
If some channels are missing (or none have
been found), you will probably need to
rescan or improve signal.