20
+31(0)78 - 615 20 33
[email protected]
www.altec.nl
+32(0)2 - 270 34 88
[email protected]
www.altec.be
NL
BE
3.3.2
Sensor setup
Labels with a
gap
(spacing)
Labels with a
notch
(cut out hole)
Continuous
media (no detection)
A.
Gap sensor
This is the most used sensor. Use this sensor when
labels have a gap between them. This can be space
between the labels or a (cut out) notch in the media.
Examples
•
Nameplate labels
•
Print&Laminate labels
•
Print&Protect labels
•
ResoPrint labels
•
Self-laminating cable labels
•
ADS Sleeves
•
Industrial tags
•
Component labels
•
Welding label
•
Paintlabel
•
ToughSurface
•
Industrial vinyl
•
Inspection labels
•
Laboratory labels
•
Continuous media
Labels with a
notch
out of range of gap sensor
Black mark sensor
The two small dots are the sensor
B.
Black mark sensor
Use the black mark sensor when a media has a notch
that is out of range of the gap sensor - or when media
has black marks on the back of the label.
Position this sensor accurately under the notch of the
label. The two small dots of the sensor should be
exactly under the gap.
Examples
•
ADC Cable markers
•
Cable flags
•
Standard sleeves
•
Wire tags
•
P- & T- labels
•
Repositionable cable labels
•
Lockout / Tagout tags
•
High temperature tags
•
Magnetic labels
Close the top cover of the printer after loading the media and setting up the sensor.
Example of media
with
black marks
