© 2003 Altec Lansing Professional
y
1000 W. Wilshire Blvd., Suite 362
y
Oklahoma City, Oklahoma 73116
Phone: 1.405.848.3108
y
Fax: 1.405.848.3217
y
Email: [email protected]
1662A
Revision 01
1 2 3 4
1662A Mixer
Gymnasium
Mic
Mic
1/4"
RCA
Custom Panel
4200A
DS912-8A
Rear Panel View
ARCHITECT’S AND ENGINEER’S SPECIFICATIONS
The unit shall be a six input mixer with two selectable outputs. Each input channel shall have a switch to select
output A, A+B or B and a level control on the front panel. Each input channel shall have bass & treble controls
located on the front panel. These controls shall consist of high and low shelving points fixed at 90Hz and 8kHz
with 12dB of boost or cut. On the back panel each input channel shall have a 20dB pad, an in/out insert point
on a ¼” TRS connector, and a Euroblock connector for balanced microphone and line inputs. +48VDC phantom
power for each input must be available (back panel switch).
Each of the two outputs shall have a level control on the front panel and a Euroblock connector on the back.
The outputs shall be active servo balanced.
The mixer unit shall be no higher than two rack spaces and must be fully covered with a five year warranty. The
dimensions shall be 19 inches (48.3cm) wide by 3.5 inches (8.9cm) high by 6.6 inches (16.8cm) deep. The
mixer shall weigh 10 pounds (4.5 kg). The mixer shall be the Altec Lansing Professional model 1662A.
As we are continually striving to improve Altec Lansing products, specifications are subject to change without notice.
VISIT WWW.ALTECPRO.COM FOR
•
Specification sheets in .pdf format. Download page 1 of the specification sheet for your submittals.
•
One paragraph A&E Specifications in .doc format
