17
•
When the robot is ready to clean, press the Pause/Play button (labelled in
Figure 2
).
The Pause/Play button will not work unless the Power Switch (See
Figure 6
for
location of Power Switch) is on AND the robot is mounted in its Mounting Bracket.
•
Once the Pause/Play button is pressed, Giddel will start cleaning your toilet
autonomously and the Robot Status LED light turns to solid BLUE.
•
If the Giddel Reservoir is empty or has too little water, the internal pump may operate
noisily as it starts feeding air instead of water. This is a gentle reminder that the Giddel
reservoir needs to be refilled, and is not a cause for concern.
•
If you press the Pause/Play button in the middle of the cleaning operation, Giddel will
pause. You may press the Pause/Play button again to resume the Cleaning Cycle.
•
Giddel cleans your toilet in a systematic fashion – the rim (surface, inner, under) and
the toilet bowl interior down to the exit in approximately 5 minutes.
•
Once the Cleaning Cycle is finished the robot returns to its HOME position (see
Figure
7
) and beeps to get your attention, indicating that the cleaning cycle is complete.
•
If you wish to clean your toilet one more time, please turn the Power Switch off (from
‘1’ to ‘0’), wait around 10 seconds and restart Giddel; otherwise, turn Giddel off,
unmount Giddel from the Mounting Bracket, by squeezing the Release Button (
Figure
7
) and then pulling Giddel out of the Mounting Bracket by the handle and Mounting
Rod (
Figure 2
) if necessary. Flush the toilet and replace Giddel in its Charging Station
or carry it to the next toilet to be cleaned. Any time you press the Reset button shown
in
Figure 2
(the robot’s right eye), the power will go off momentarily and come back
on again. This will restart and re-initialize the robot to its HOME position. In case of
an emergency, for example, if the robot gets stuck, you may use the Reset button.
Alternatively, you may turn the Power Switch off.
Disclaimer: While Giddel makes every effort to clean the toilet thoroughly, the results of
cleaning may vary from toilet to toilet due to large variability in the size and shape of
toilets. Altan Robotech does not guarantee any particular finish or level of cleaning.
4.4 Replacing the Cleaning Brush
There are 3 Cleaning Brushes supplied with your Giddel.
Figure 9
shows one such brush.
It has a female thread at the back which screws on to the male thread on the end of the
telescopic arm (
Figure 8
). To attach a new Cleaning brush, simply rotate the Cleaning
Brush in a clockwise direction onto the male thread of the telescopic arm, until it clicks
into place and turns no more. To remove the Cleaning Brush, wear disposable gloves and
unscrew the brush in an anti-clockwise direction and dispose of safely.
Содержание GIDDEL
