4
Altai Technologies Ltd. All rights reserved
Quick Setup Guide
Cable Feed-Through
1.
Prepare a pair of needle-nose pliers.
2.
Follow the instructions on the drawing below to cut a feed-through hole
for ETH0 Port cabling.
3.
Cut another hole with pliers for ETH1 Port cabling if necessary.
Mounting Options
Option 1: Pole Mount
1. Orient the device to point to the target coverage
area (for AP mode) or to the target AP (for
Station mode).
2. Loop two cable ties through the slots on the back
of the device and then wrap them around the
pole.
3. Tighten the cable ties to ensure the device is
firmly in place.
Option 2: Wall Mount
1. Using the back mount base as reference, mark
the location of the mounting holes on a flat wall
surface.
2. Drill mounting holes on the marked locations. The
two holes should be 60mm (2.3 inches) apart.
3. Fasten the device to the wall using the mounting
anchors and screws provided.
For ETH1 Port Cabling
For ETH0 Port Cabling
60mm
