Altai Technologies Ltd. All rights reserved
C1n Series WIFI AP/CPE Web-admin Configuration Manual
TPS15-003_rev1.3
Data Rate
: Specify which data rate that AP will or will not serve. The fact is that low
data rate transmissions consume more air time than high data rates. It may affect the
system performance. By disabling low data rates, AP rules out some remote clients
with poor signal strength and hence low link data rate, preventing them from
consuming too much air time and leaves the air time for higher data rates
transmissions. In this way, overall system performance can be improved. The most
common way we use it is to disable low data rates (e.g., 1M, 2M) when the AP
performance is reported poor.
Multicast Traffic Data Rate Setting
: Specify the data rate of multicast packet; C1n
allows multicast packets to be sent in higher rates rather than commonly used (1
Mbps at IEEE 802.11b mode, 6 Mbps at IEEE 802.11g/a mode). This is Altai’s proprietary
feature; it may be incompatible with the devices from other vendors. If the sender
and receiver, which are Altai’s products, have the same setting, they can achieve
better multicast packet throughput performance.
AirFi Setting
AirFi Mode
: Enable or Disable AirFi function; AirFi technology is the latest advanced
software control wireless algorithm developed by Altai for optimizing network
throughput capacity performance. Using the Altai AirFi control algorithm can optimize
the wireless bandwidth for the high speed clients as well as the low speed clients (i.e.
11b and 11g clients), and as a result the system throughput can be improved
substantially.
AirFi Level
: There are four options for AirFi level: Level I, Level II, Level III and Custom.
AirFi level I is recommended. When select “Custom”, user can configure
AirFi Level
Custom
value.
5.4.1.1.4.
QoS Configuration
User may specify the Radio0 QoS setting via
Configuration
Wireless
Radio0
QoS
.
