35
Altai Technologies Ltd. All rights reserved
AX500 Series Installation Manual
Figure 10-5 Rubber Mastic Ring around Cable Gland Body
Tape Wrapping around Ethernet Ports
1.
Make sure the Ethernet cable and its connectors are absolutely dry.
2.
Follow the above Section “Ethernet Cable Feed-Through” and Section 8 “Ethernet Cable Wiring and
Pinout” to crimp the Ethernet cable.
Figure 10-6 Ethernet Cable Feed through Cable Gland with Rubber Mastic Ring around
3.
Plug the RJ45 jack into the Ethernet port.
Figure 10-7 RJ45 Connector Plugged into Ethernet Port
4.
Wrap
a layer of electrical tape
starting from the Ethernet cable, 1.5” (38mm) below the cable gland, up
to the cable connector. Overlap the tape to half-width. The tape should cover the entire cable
connector body.
The tape can be applied in one or more strips if necessary. A strip can be coiled onto an applicator
such as a pencil. Apply only enough tension to get good adhesion and keep the tape smooth.
Before
After
Rubber Mastic Ring
