Diagram shows completely assembled ALTA light bar from behind
Horizontal Mounting Beam, and Struts shown above
Installation:
1)
Open hood and prepare to remove bumper cover. Locate and remove plastic connectors and screws under lower portion of
bumper. Locate and remove (2) torx screws at the top of the bump on each corner. Remove 8mm bolts behind side markers
inside of wheel well area. (See factory service manual for specific bumper skin removal instructions.)
2)
Slide bumper skin off a few inches to allow enough room to unplug side marker lights and fog lights.
3)
Place bumper skin on ground making sure to put something protective between it and the ground.
4)
Remove (10) bolts and nuts securing bumper beam to chassis.
5)
Set beam back into bumper skin. Place ‘L’ brackets on bumper beam, and through holes in bumper skin.
6)
Align struts centered with bumper beam and make sure they are 16.5” apart. Mark (4) holes to be drilled with sharpie. Typically
holes will be 3-‐3/8” and 5-‐1/4” from top of beam. This is not super important to be perfect, but make sure its close to these
dimensions.
7)
Separate bumper skin from bumper beam and drill (4) 7/16” holes (marked in step 4) completely through both sides of the
bumper beam. NOTE: There is an extrusion running close to lower drilled hole. Make sure that if you run into this, you move the
hole up to clear it.
8)
Using supplied hardware mount each ‘L’ bracket to bumper beam. (See picture below)
