Rally Style Lamp Kit Cooper S Models
2015-‐02-‐24
Thank you for purchasing this ALTA product for your car! Installation of this product should only be performed by persons experienced with installation of aftermarket
performance parts and proper operation of high performance vehicles. If vehicle needs to be raised off the ground for installation, the installer must use proper jacks, jack-‐stands
and/or a professional vehicle hoist for safety of the installer and to protect property. If the vehicle is lifted improperly, serious injury or death may occur! Please read through all
instructions before performing any portion of installation. If you have any questions, please contact our tech department prior to starting installation. We can be reached in any of
the following methods:
Instant Chat off the main page of
www.ALTAperformance.com
Or simply call our tech team at 503-‐693-‐1702
SPECIAL NOTES:
•
Use of the factory service manual can be very helpful during the installation. These can be purchased at the dealership or online.
http://www.realoem.com
has diagrams for the entire car, which can also be helpful.
•
This installation will require cutting and drilling into both bumper beam and bumper skin. Test fit all components prior to cutting and drilling.
ALTA performance is not responsible for repairs from mis-‐installation.
•
The light bar is adjustable up and down, and left to right.
Ensure the bar is mounted low enough to clear the bumper, but not too low as to
cause an interference.
Parts Included with the ALTA Rally Light Bar:
•
(1) Set of Left and Right Mounting Struts
•
(1) Horizontal ALTA Mounting Bar
•
(4) 5/16-‐18x2.75” Grade 8 Hex bolts
•
(8) 5/16 Flat Washer
•
(4) 5/16 Lock Washer
•
(4) 5/16-‐18 Grade 8 Nut
•
(2) 7/16-‐20x.750” Black Oxided SS hex bolt
•
(6) 7/16 Black Oxide Washers
•
(2) Lamp kits (optional)
Preparation:
1)
Loosely mount lamps supplied with kit or those purchased separately to horizontal mounting beam with ‘ALTA’ logo facing forward and readable
from the front of the vehicle.
2)
Using lamp assembly as a guide, mark holes in lower grill where “L” brackets will come through. NOTE: Check clearance from all facets of lamps,
beam etc. prior to final determination of holes!
Light bar should be mounted as low as possible to ensure light do not hit upper portion of
bumper.
These holes will need to be approximately 1” in diameter and 16.5” apart from centerline of each hole. Take time with aligning light bar
assembly to bumper beam, this will pay off for final installation.
