Horizontal Mounting Beam, and Struts shown above
Installation:
1) Remove bumper cover. Locate lower pop-it connectors, screws at the top of bumper cover, and screws behind side
markers. (See factory service manual for specific bumper skin removal instructions.)
2) Remove beam and set beam back into bumper skin. (See factory service manual for specific bumper beam removal
instructions.)
3) Using holes made in bumper skin, place ‘L’ brackets on bumper beam, and through holes in bumper skin.
4) Mark (4) holes to be drilled through bumper beam. Separate bumper skin from bumper beam.
5) Drill (4) 7/16” holes (marked in step 4) completely through both sides of the bumper beam.
6)
Using supplied hardware mount each ‘L’ bracket to bumper beam. (See picture below)
Struts shown bolted to back side of bumper beam after aligning with bumper cover
Bumper beam and struts in place and ready for bumper skin
