Assembly instructions
Turn Off power supply before starting any installation.
Do not connect the device under power.
Another installation / assembly / materials / types than provided in the
manual sheets, release us from any electrotechnical and electrostatic re-
sponsibility.
It is recommended that these products are installed by a qualified elec-
trician.
01.
Only install on a suitable base (aluminium - thermal management,
grip).
02.
Can be cut to length ...
03.
...
only at certain points!
02
03
+
-
black
red
04
05
06a
06b
06c
08
07
04.
Power supply 24V DC
red = plus (+) / black = ground (-).
Do not wire the wrong way!
Connect the module only with a suitable LED-
power supply 24V DC constand voltage and enough power.
05.
A feed line can be soldered to the remainder module.
06a.
Segments can be connected by soldering of abridge.
Solder up the upper soldering point (
pict. 06b
) with the lower point (
pict.
06c
). Soldering points become visible as soon as protection foil is taken
off. Don’t take off the foil completely as not to lose the adhesive
power of FLEXY. Attention! Maximum 5m of Flex strip can be installed with
one feeder. For more, additional feeding is required.
07.
Minimum radius of bending 3 cm.
08. Do not bend
, bending will damage the conductors.
01
!
