Assembly instructions for LED panel
Carefully remove the LED panel from its packaging.
01
Turn Off power supply before starting any installation.
Do not connect the device under power.
Connect the supply cables according to the electrical regulations to the
primary connection 230V AC to LED converter.
02
The electrical connection from LED panel to the converter is connected
with a plug-in connector. Do not unplug before switching on, also not during
operating the lamp.
Only use the supplied LED converter! Other converters or transformers may
destroy the light.
03
Over the corner edge of the light carefully put it into the ceiling section.
Avoid mechanical tensions on panel, the light should have some space.
04
After installation and connection, switch on the mains voltage all-pole.
Switch on the associated circuit breaker or turn the fuse on.
It is not allowed to cover LED panel and LED converter with heatinsula-
ting cover sheet or similar materials!
Additional drillings in the LED luminaire are not allowed!
Do not place the LED converter on the LED pendant luminaire to avoid
unnecessary transfer of heat.
Another installation / assembly / materials / types than provided in the
manual sheets, release us from any electrotechnical and electrostatic
responsibility.
Fixing materials:
The warranty is void if the buyer or a third party repairs or modifies the
luminaire.
Please check that the lamp has an electronic ballast with connection for
functional earth. If so, please connect the functional earth according to
the valid standards and guidelines!
In case of ceiling installation
place LED converter side-
ways in the luminaire.
Plug-in and lock after half rotation.
AC
~
AC~
AC
~
AC~
AC
~
AC~
AC
~
AC~
02
03
OFF
01
ON
04
Pendulum mounting with
mounting frame
Art.-Nr. ELEDN-AUR626
and steel cable suspension set
Art.-NR. Z-ELEDN
Grub screw for frame
protection
Z-BELEDQ
07b
A
B1
B2
C1
B3
C2
4x 4x
4x
4x
4x
4x
Surface mounting with ceiling cutout. Accessory
Z-BELEDQ
required.
Required ceiling cutout:
608x608 mm.
