Electric Rim Strike
AL150
www.alpro.co.uk
01202 676262
01202 680101
Registered in England & Wales 1925537 ©
April 2018
IEC. All rights reserved. All dimensions are nominal and subject to tolerances
CONVERSION: POWER TO LOCK <=> POWER TO OPEN
Figure 4A
Figure 4B
WARNING:
Do not press on the keeper to release when the
spring screw is not totally secured in position, this
will cause damage to the spring barbell. When
changing function, micro switch will spring out.
Procedures to convert Power to Open (Figure
4B) to Power to Lock (Figure 4A):
Step 1: Remove the two cover plate screws.
Step 2: Remove the lock body from the cover
housing.
Step 3: Remove the spring screw from the end
part of the strike body.
Step 4: Remove the Barbell and replace in
reverse position with long part in and short
part out.
Step 5: Replace the spring screw.
Step 6: Refit the lock body into the cover housing
and screw in the two cover plate screws.
Procedures to convert Power to Lock (Figure
4A) to Power to Open (Figure 4B):
Step 1: Remove the two cover plate screws.
Step 2: Remove the lock body from the cover
housing.
Step 3: Remove the spring screw from the end
part of the strike body.
Step 4: Remove the Barbell and replace in
position with short part in and long part
out.
Step 5: Replace the spring screw.
Step 6: Refit the lock body into the cover housing
and screw in the two cover plate screws.
ELECTRIC STRIKE MAINTENANCE
Maintenance should be carried out every
6 months, or higher for heavy duty door
traffic.
Electric strikes should be fitted exactly in
accordance with the Alpro fixing
instructions, ensuring and maintaining all
relevant door gaps and clearances.
Under no circumstances use a spray
lubricant, as this type of solvent can
damage electronics. Electrical parts with
the strike need no maintenance.
If required fit a protective diode as close
to the coil as possible to protect the
system from transient peaks
.
Ensure on a regular; basis the whole of the
door system is checked (lock case, door
closer, strike plate, handles etc.) to ensure
the desired level of door operation and
security is being maintained
.
PLEASE NOTE:
The warranty for the strike is void if:
The strike is assembled incorrectly
Parts fitted to the strike which are not
approved Alpro Parts
The strike is incorrectly wired
There is incorrect voltage applied to the
strike
Alpro electric strikes should be installed
by suitably qualified engineers
