(5A)
(5A)
LCD COLOR NAVIGATION MONITOR
TME-C005AS
POWER
LIST
N/H
M/G
DTR
CANCEL
ENTER
MENU
VOICE
ZOOM/PAGE
PLAN
GPS RECEIVER
CD-ROM DRIVE
GYROSCOPE
NVE-N851A**
TME-C005AS
Optional
KWE- 660N
(4pin)
(10 pin)
POWER
EX-2
EX-1
TO DISP.
MIC/SW
GPS ANT.
13P RGB Extension Cable Included
BRIGHT
POWER SUPPLY
NAVIGATION INPUT
DISPLAY OUTPUT
MONITOR
INTERFACE
BOX
VPE-B005
Installation
To avoid unnecessary signal wiring, it is better to mount the Unit as close as possible to the NVE-N851A.
DO NOT MOUNT THE UNIT IN LOCATIONS THAT WILL BE IN THE VICINITY OF MOISTURE OR EXTREME
HEAT (such as the engine compartment).
The Unit can be mounted by using self-tapping screws or Velcro™ tape. Make sure you have all the necessary
parts and tools. Then, begin mounting according to one of the following procedures:
Screw-down Mounting (Fig. 1):
1. Using the unit as a template, hold it at its mounting location and mark the holes to be drilled. Before drilling,
make sure that there are no objects that could be damaged behind the mounting surface.
2. Drill holes and secure the unit with self-tapping screws (M4 x 14) supplied.
Velcro™ Tape Mounting (Fig. 2):
This installation method is suggested when the mounting location does not permit drilling.
USE THIS METHOD ONLY WHEN THE UNIT IS MOUNTED ON A HORIZONTAL SURFACE. NEVER MOUNT A
UNIT UPSIDE-DOWN USING THE VELCRO™ TAPE.
1. Remove the adhesive protective paper from one side of the Velcro™ tape.
2. Attach the exposed adhesive side to the underside of the Unit, in a central location. Do not cover the serial number.
3. Make sure the mounting location is clean, dry and free from contaminants.
4. Remove the protective strip from the other side of the Velcro™ pad.
5. Press the unit onto its mounting location.
Numbers Identification
1
Self-Tapping Screws (M4 x 14) (Included)
2
Floor/Trunk
3
Velcro™ Tape (Included)
4
Press onto the carpet.
1
2
Fig. 2
Fig. 1
Connection
3
4
Adjusting Brightness of Monitor
The brightness of TME-C005AS connected is adjusted from this unit.
Adjust by turning the knob to obtain a preferrable brightness.
Dimmer In (Illumination) (+) (White/Blue)
Parking Brake (Yellow/Blue)
Reverse (+) (Orange/White)
Speed Sensor (Green/White)*
Connect to VSS (Digital or Analog 0V – 3V)
Mute (Pink/Skyblue)
To the Acc power lead
Connect to a metal part of
chassis body with screw.
To the illumination signal line
To the parking brake signal line
To reverse lights (+12V signal)
To the vehicle speed pulse line
To audio head unit MUTE wire or
Alpine "IN-INT" function wire
Ground (Black)
*
Improper connection of the speed pulse line
may cause important safety features of the
vehicle to fail (such as the brakes or air bag).
Such failures may result in an accident and
loss of life. We strongly recommend that the
installation be performed by a trained,
authorized Alpine dealer.
** The power supply cable supplied with the
NVE-N851A is not used.
Note: Make the connections and adjustments
by referring to the Manual for the product
to be connected.
Power supply cable
BATTERY
Battery Lead (Yellow)
Acc (Ignition) (Red)
