Alpine TDM-7574E, Руководство пользователя

Страница: 7 / 19

5
-EN
2
Press and hold the A.S.U. (Automatic Setup)
button for at least 3 seconds to activate the
A.S.U. mode.
"ASU" blinks in the display.
The unit automatically performs the following
operations.
1. Activates the Auto Memory mode.
2. Gradually sets the Bass, Treble, Balance and
Fader controls to their center positions.
3. Gradually increases the volume to the
position 12 in the display.
4. Turns the Loudness on.
5. Ends the A.S.U. mode.
Turning Power On and Off
1
Press the PWR (Power) button to turn on the
unit.
NOTE
The unit can be turned on by pressing any other button
except the eject
c
button.
The volume level gradually increases to the
previous level you were listening to before the
unit was turned off. Press the PWR button again
to turn off the unit.
Turning Loudness On/Off
Loudness introduces a special low- and
high-frequency emphasis at low listening levels to
compensate for the ear's decreased sensitivity to
bass and treble sound.
1
Press and hold the LOUD button for at least
2 seconds to activate or deactivate the loudness
mode. The display shows "LOUD" when the
loudness mode is activated.
Adjusting Volume/Bass/Treble/
Balance (Between Left and Right)/
Fader (Between Front and Rear)
1
Press the MODE button repeatedly to choose
the desired mode.
Each press changes the modes as follows:
NOTE
If the
K
or
L
button is not pressed within 5 seconds
after selecting BASS, TREBLE, BALANCE, or FADER
mode, the unit automatically returns to VOLUME mode.
2
Press the
K
or
L
button until the desired sound
is obtained in each mode.
NOTE
The BASS and TREBLE settings for each source (FM,
AM, TAPE, and CD) are automatically memorized. These
settings remain until you manually change them.
Displaying Time
1
Press the CLK (clock) button to display the time.
The unit displays the clock time.
NOTE
Selecting any of the tuner, tape and CD functions while
in the clock mode will interrupt the time display
momentarily. The function selected will be displayed for
about 5 seconds before the time returns to the display.
2
Press the CLK (clock) button to turn off the time
and to show other functions.
Setting Time
1
Press and hold the CLK (clock) button for at
least 2 seconds while the display is showing the
time.
The time indication will begin to blink (for 5
seconds).
2
Press the CT button while the time indication is
blinking to set seconds to "0."
3
Press the H button to adjust the hours while the
time indication is blinking.
4
Press the M button to adjust the minutes while
the time indication is blinking.
The time indication will stop blinking 5 seconds
after the last adjustment. The time will
automatically be set.
→
VOL
→
BAS
→
TRE
FAD
←
BAL
←