29
-EN
Slope Adjustment
3
-3 Turn the
Double Action encoder
to adjust the
slope.
Adjustable slope: FLAT, 6 dB/oct., 12 dB/oct., 18 dB/oct.,
24 dB/oct.
4
Repeat steps 1 to 3 to make adjustment to the other
bands.
•
You can select the next band by pressing and turning the
Double
Action encoder
.
•
While adjusting the X-OVER, you should consider the frequency
response of the connected speakers.
•
About the 2.2ch (3WAY)/4.2ch (FRONT/REAR/SUBW.) system
You can switch to 2.2ch (3WAY)/4.2ch (FRONT/REAR/SUBW.)
system mode with the 2.2ch (3WAY)/4.2ch (FRONT/REAR/SUBW.)
switch on the PXA-H100. For details, refer to the Owner’s Manual of
PXA-H100.
•
The User Preset screen can be recalled in the normal mode by
pressing and holding
PRESET
for 2 seconds.
When the subwoofer is on, you can adjust the subwoofer output level
(refer to page 20).
OFF
ON (Initial setting)
When the subwoofer is on, you can select either SYS 1 or SYS 2 for the
desired subwoofer effect.
1 (Initial setting)
2
NORMAL (Initial setting)
REVERSE
The subwoofer output phase is toggled SUBWOOFER NORMAL (0°)
or SUBWOOFER REVERSE (180°). To adjust the level, turn the
Double Action encoder
.
You can set the subwoofer output to stereo or monaural. Make sure to
set the correct output for your subwoofer type.
STEREO (Initial setting)
MONO
Depending on the response characteristics of the speaker, care should be
taken when setting the response slope of the high range speaker to
FLAT in 2.2ch (3WAY) mode (see “Adjusting the Crossover Settings
(X-OVER)” on page 28), as speaker damage may result.
MAKER’S (Initial setting )
USER’S
This setting gives you a choice of 5-band parametric, or 7-band graphic
equalizer.
PARAMETRIC (Initial setting)
GRAPHIC
NORMAL (Initial setting)
INDIVIDUAL
You can change the unit, (cm or inch) of time correction.
CM (Initial setting)
INCH
Turning Subwoofer ON/OFF
Setting the Subwoofer System
SYS 1 :
Subwoofer level changes according to the main
volume setting.
SYS 2 :
Subwoofer level change is different from the main
volume setting. For example, even at low volume
settings, the subwoofer is still audible.
Setting the Subwoofer Phase
Setting the Subwoofer Channel
(SUBW CHANNEL)
STEREO:
Subwoofer stereo (L/R) output
MONO:
Subwoofer monaural output
Setting the Response Slope for the High
Range Speaker (TW Setup)
MAKER’S:
As protection from possible speaker damage, FLAT
cannot be set for the response slope of the high
range speaker in 2.2ch (3WAY) mode.
USER’S:
The FLAT setting is possible in 2.2ch (3WAY) mode.
Setting EQ mode
Setting the Filter type
NORMAL (L=R):
Left and right speakers are adjusted
equally.
INDIVIDUAL (L/R):
Left and right speakers are individually
adjusted.
Setting the Time Correction Unit (TCR)
Содержание iDA-X311
Страница 2: ......
