Alpine iDA-X311, Руководство пользователя

Страница: 39 / 42

37
-EN
Installation
• The main unit must be mounted within 35 degrees of the horizontal
plane, back to front.
Removal
1. Remove the detachable front panel.
2. Use a small screwdriver (or similar tool) to push the
locking pins to the “up” position (see above drawing).
As each pin is unlocked, gently pull out on the unit to
make sure it does not re-lock before unlocking the
second pin.
Pull the unit out, keeping it unlocked as you do so.
Caution
Do not block the unit’s heat sink, thus preventing air circulation.
If blocked, heat will accumulate inside the unit and may cause a
fire.
Caution
When you install this unit in your car, do not remove the
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
1
* If the installed mounting sleeve is loose in the main unit, the pressure
plates may be bent slightly to remedy the problem.
Remove the mounting sleeve from the main unit (see
“Removal” on page 37). Slide the mounting sleeve
into the dashboard and fix it with the metal shackles.
Heat sink
Detachable
Front Panel
Less than 35°
Pressure Plates
*
Dashboard
This unit
Mounting Sleeve
(Included)
Bracket
Rubber Cap
(Included)
Hex Bolt
(Included)
2
When your vehicle has the Bracket, mount the
long hex bolt onto the rear panel of the iDA-X313/
iDA-X311/iDA-X311RR and put the Rubber Cap on
the hex bolt. If your vehicle does not have the
Mounting Support, reinforce the head unit with
the metal mounting strap (not supplied). Connect
all the leads of the iDA-X313/iDA-X311/
iDA-X311RR according to details described in the
CONNECTIONS section.
• For the screw *, provide a proper screw to the chassis installing
location.
3
Slide the iDA-X313/iDA-X311/iDA-X311RR into the
dashboard. When the unit is in place, make sure
the locking pins are fully seated in the down
position. This can be done by pressing firmly in
on the unit while pushing the locking pin down
with a small screwdriver. This ensures that the
unit is properly locked and will not accidentally
come out from the dashboard. Install the
detachable front panel.
Metal Mounting Strap
Screw
Bolt Stud
This unit
Hex Nut (M5)
Lock pin
* The illustrator is for iDA-X313.