Alpine Hemlock, Руководство пользователя

Страница: 10 / 11

1. Disconnect motor wire from motor to Main Board.
2. Move air inlet right cover by loosening 4 screw(Be sure not to lose them).
3. Move motor fix bracket and motor fix rubber ring by loosening 4 screw(Be sure not to lose them).
4. Pull out motor lightly and disconnect two wire. Be sure two wire goes through motor house hole smooth.
5. Replace a new motor and keep it well installed. It is important to install the two rubber ring evenly.
6. It is recommended to weld the wire on motor‘s two connection pin.
7. Pull the two wire from the motor house lightly.
8. Reconnect motor wire as diagram.
If it is a normal air filter:
Just pull it out as it is soft. Then replace a new one.
If it is a HEPA air filter:
1. Remove air inlet right cover by loosening 4 screw(Be sure not to lose them).
2. Replace a new HEPA.
3. Replace over and do not over tight it.
Replace filter or HEPA filter (If supplied)
Replace motor
HEPA
Motor
Motor fix rubber ring Motor fix bracket