10
-EN
Setting Time
1
Press and hold
AUDIO/SETUP
(CDE-W235BT only) for at
least 2 seconds or press
SETUP
(CDE-W233R only) to
activate the SETUP selection mode.
2
Turn the
Rotary encoder
to select GENERAL, and then
press
ENTER
.
AUDIO
GENERAL
DISPLAY
TUNER
IPOD
BLUETOOTH
*
*
CDE-W235BT only.
3
Turn the
Rotary encoder
to select the CLOCK ADJ mode,
and then press
ENTER
.
The time indication will blink.
4
Turn the
Rotary encoder
to adjust the hours while the
time indication is blinking.
5
When the hour has been adjusted, press
ENTER
.
6
Turn the
Rotary encoder
to adjust the minutes while the
time indication is blinking.
7
Press and hold
AUDIO/SETUP
(CDE-W235BT only) for at
least 2 seconds or press
SETUP
(CDE-W233R only) to
return to normal mode.
Notes
• To synchronize the clock to another clock/watch or radio time
announcement, press and hold
ENTER
for at least 2 seconds after
setting the “hour”. Minutes will reset to “00”. If the display shows over
“30” minutes when you do this, the time will advance one hour.
• Pressing
will return to the previous mode.
• Pressing and holding
for at least 2 seconds will return to normal
mode.
• If no operation is performed for 60 seconds, the unit will return to
normal mode automatically.
• Even when AUTO CLOCK is set to ON (refer to “Setting the Time to
automatically Adjust” on page 13), the time can be adjusted manually.
At the same time, if there is an adjustment request from RDS, the time
will be adjusted automatically by RDS data.
Listening to Radio
1
Press
SOURCE
to select TUNER mode.
2
Press
BAND
repeatedly until the desired radio band is
displayed.
F1 (FM1)
F2 (FM2)
F3 (FM3)
MW
LW
F1 (FM1)
3
Press
TUNE
A.ME
to select the tuning mode.
DX SEEK (Distance mode)
SEEK (Local mode)
off (Manual
mode)
DX SEEK
Note
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4
Press
or
to tune in the desired station.
Holding down
or
will change the frequency
continuously.
Controllable with Remote Control
This unit can be controlled with an optional Alpine remote control.
For details, consult your Alpine dealer. Point the optional remote
control transmitter at the remote-control sensor.
Remote control sensor
Radio
SOURCE/
Preset buttons
(1 through 3)
Preset buttons
(4 through 6)
/ENTER
Rotary encoder
TUNE/A.ME
BAND