Alpine CDE-7871E, Руководство пользователя

Страница: 23 / 24

21
-EN
1
Antenna Receptacle
2
Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power
antenna, if applicable.
3
Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your
amplifier or signal processor.
4
Illumination Lead (Orange)
This lead may be connected to the vehicle's
instrument cluster illumination lead. This will allow
the backlighting of the CDM-7874EB to dim
whenever the vehicle's lights are turned on.
5
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle's
fuse box or another unused power source which
provides (+)12V only when the ignition is turned on
or in the accessory position.
6
Battery Lead (Yellow)
Connect this lead to the positive (+) post of the
vehicle's battery.
7
Ground Lead (Black)
Connect this lead to a good chassis ground on the
vehicle. Make sure the connection is made to bare
metal and is securely fastened using the sheet metal
screw provided.
8
Fuse Holder (15A)
9
Power Supply Connector
!
Right Front (+) Speaker Output Lead (Gray)
"
Right Front (–) Speaker Output Lead (Gray/
Black)
#
Right Rear (–) Speaker Output Lead (Violet/
Black)
$
Right Rear (+) Speaker Output Lead (Violet)
%
Left Rear (+) Speaker Output Lead (Green)
&
Left Rear (–) Speaker Output Lead (Green/
Black)
(
Left Front (–) Speaker Output Lead (White/Black)
)
Left Front (+) Speaker Output Lead (White)
~
Front Output RCA Connectors (CDM-7874EB
only)
~
Rear/Subwoofer RCA Connectors (CDE-7871E
only)
RED is right and WHITE is left.
+
Rear/Subwoofer Output RCA Connectors (CDM-
7874EB only)
RED is right and WHITE is left.
,
RCA Extension Cable (Sold Separately)
-
DIN Connector (CDM-7874EB only)
Connect this to the DIN connector on the CD
Changer.
.
DIN Extension Cable (Sold Separately)
NOTE
Older Alpine CD Changer came with standard, straight
type DIN connectors. In installations where an L-type
connector would simplify installation, the Alpine 4910
02
Adaptor can be used (Sold Separately).
To prevent external noise from entering the audio system.
•
Locate the unit and route the leads at least 10cm away from the car harness.
•
Keep the battery power leads as far away from other leads as possible.
•
Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
•
If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries
various Alpine noise suppressors, contact them for further information.
•
Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.