Alpine CDE-1338T, Руководство пользователя

Страница: 8 / 38

8
-EN
Accessory List
• Head Unit ..................................................................................1
• Power Cable ..............................................................................1
• Microphone ..............................................................................1
• Mounting Sleeve ......................................................................1
• Carrying Case............................................................................1
• Bracket key ...............................................................................2
• Screw (M5 × 8) ..........................................................................4
• Owner’s Manual..................................................................1 set
Turning Power On and Off
Press SOURCE

to turn on the unit.
Note
• The unit can be turned on by pressing any other button except

and
e
.
Press and hold SOURCE

for at least 2 seconds to turn
off the unit.
Note
• The first time power is turned on, the volume will start from level 12.
Source Selection
Press SOURCE  to change the source.
TUNER

DISC

USB AUDIO/iPod
*1

BT AUDIO
*2

AUXILIARY
*3

TUNER
*1
Only when the iPod/iPhone is connected.
*2
Only when BT AUDIO is set to ON. Refer to “Setting the
BLUETOOTH Connection (BT IN)” on page 20.
*3
Only when AUX SETUP is set to ON. For details, refer to
“Setting the AUX SETUP Mode” on page 18.
Detaching and Attaching the Front Panel
1
Turn off the unit power.
2
Press e at the lower left side until the front panel pops
out.
3
Grasp the left side of the front panel and pull it out.
Notes
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel). This is not a
malfunction.
• To protect the front panel, place it in the supplied carrying case.
• When detaching the front panel, do not apply excessive force as it may
result in malfunction.
1
Insert the right side of the front panel into the main unit.
Align the groove on the front panel with the projections
on the main unit.
2
Push the left side of the front panel until it locks firmly into
the main unit.
Notes
• Before attaching the front panel, make sure that there is no dirt or dust
on the connector terminals and no foreign object between the front
panel and the main unit.
• Attach the front panel carefully, holding the sides of the front panel to
avoid pushing buttons by mistake.
Initial System Start-Up
Be sure to press the RESET button when using the unit for the first time,
after changing the car battery, etc.
1
Turn off the unit power.
2
Remove the detachable front panel.
3
Press RESET with a ballpoint pen or similar pointed object.
Getting Started
Detaching
SOURCE/

e
AUDIO/SETUP
Rotary encoder
ENTER

Attaching
RESET button