Assembling & Using Your Product
Unpack all components carefully. Please check to ensure all parts have been removed
from the packaging.
Components:
A. Top Blade Spinner
B. Middle Blade Spinner
C. Bottom Blade Spinner
D. Curved Ring Piece 1
E. Curved Ring Piece 2
F. Curved Ring Piece 3
G. Curved Ring Piece 4
H. Small Outer Rod (x2)
I.
Small Center Rod (x2)
J.
Top Orb Lock
K. Long Inner Rod
L. Capped Nut (x6)
M. Upper Stake Connector
N. Lower Stake Connector
O. n-stake
P. h-stake
Q. Wrench
Assembling:
Assembling &
Using Your Product (Cont’d)
1
Align and insert the screw holes on the Curved Ring Piece 1 (D) to an
available two-pronged connector on both ends of the curved ring piece 3
(F). Use a capped nut (L) and secure both ends of the two pieces
clockwise tightly using the provided wrench (Q). Repeat this step to
connect the Curved Ring Piece 2 (E) and Curved Ring Piece 4 (G).
(See
diagram step 1 on previous page)
2
Insert a small outer rod (H) to the bottom of the assembled curved ring
(D+E+F+G) and then insert the bottom blade spinner (C) on top of the
outer rod.
(See diagram step 2 on previous page)
3
Insert a small center rod (I) on top of the bottom blade spinner (C). Then
insert the middle blade spinner (B) on top of the newly inserted center rod.
(See diagram step 2 on previous page)
4
Insert a small center rod (I) on top of the middle blade spinner (C). Then
insert the top blade spinner (A) on top of the newly inserted center rod.
(See diagram step 2 on previous page)
5
Insert a small outer rod (H) on top of the top blade spinner (A) The rod
should connect to the top of the assembled curved ring (D+E+F+G). Once
done, you can then insert the long inner rod (K) from the bottom and
through the previously connected small rods all the way to the top end.
(See diagram step 2 on previous page)
6
Take the top orb lock (J) and connect it to the long inner rod (K) that went
through all the way up from the bottom of the assembled curved rings
(D+E+F+G).
(See diagram step 3 on previous page)
7
Insert the upper stake connector (M) to the bottom of the assembled
curved ring (D+E+F+G) where you previously inserted the long inner rod
(K).
(See diagram step 4 on previous page)
8
Insert the lower stake connector (N) to the bottom of the upper stake
connector (M). Then Insert the n-stake (O) to the bottom of the lower
stake connector. And lastly, insert the h-stake (P) to the bottom of the n-
stake.
(See diagram step 4 on previous page)
Your garden stake is now completely assembled.
(See diagram step 5 on
previous page)
1
2