5
INSTALLATION INSTRUCTIONS
NOTE 2:
FOR USE WITH TOGGLE ANCHORS:
- If finished wall surface has wood studs that are not 16” on center,
has metal studs, or has an underlying surface of concrete block, use
1/2” bit.
- Use machine screws and flat washers (See Figure B on Page 6).
- For holes NOT located in a wood stud, toggle anchors Must be used
(See Parts List on page 2). See “Using Toggle Anchors” section.
6. Align holes in changing station with drilled holes and secure top left
corner of changing station to wall stud using the appropriate screw and
washer. Continue to secure the three (3) remaining corners using the
appropriate screws and washers as described in NOTE 1 or NOTE 2.
7. Ensure all four (4) screws are tight and snap caps over screw heads.
ALL 4 OF THESE LOCATIONS
MUST BE USED FOR SAFE
INSTALLATION. THE LOWER HOLES
ENSURE INSTALLATION THROUGH
THE METAL BRACKETS.
WARNING
!