EN 10
5. Operating the Engine
It is very dangerous to
run a chainsaw that mounts broken parts or
lacks any parts. Before starting engine, make
sure that all the parts including bar and chain
are installed properly.
• STARTING THE ENGINE
• Before starting the engine
1. Fill fuel and chain oil tanks respectively, and
tighten the caps securely.
2. Continuously push the priming bulb until fuel
comes in the bulb.
3. Set the switch to “I” position.
4. Pull out the choke knob to the second-stage
position. The choke will close and the throttle
lever will then be set in the starting position.
When restarting immedi-
ately after stopping the engine, set the Choke
NOTE
WARNING!
knob in the first-stage position (choke open and
throttle lever in the starting position).
Once the choke knob has
been pulled out, it will not return to the operating
position even if you press down on it with your
finger. When you wish to return the choke knob
to the operating position, pull out the throttle
lever instead.
Before you start the engi-
ne, make sure the saw chain is not contacting
anything.
• Starting the engine on the ground
Do not start the engine
while the chain saw hangs in one hand. The
saw chain may touch your body. This in very
dangerous.
Keep clear of the saw
chain as it will start rotating upon starting of
engine.
5. While holding the saw unit securely on the
ground, pull the starter rope vigorously.
6. When engine has ignited, first push in the
choke knob to the first-stage position and
then pull the starter again to start the engine.
7. Allow the engine to warm up with the throttle
lever pulled slightly.
WARNING!
WARNING!
WARNING!
NOTE
5. Operating the Engine
(1) Chain oil
(2) Fuel
(1) Throttle interlock
(2) Throttle lever
Choke knob:
(1) When the engine is
cool
(2) When the engine is
warm up
(3) After the engine
starts
(1) Switch