Alpina AS 5148 Li, Инструкция по эксплуатации

Страница: 18 / 332

EN - 7
E. Led lights
F. Handle pivot closure
G. Central handle
H. Ignition key
I. Exhaust chute
J. Deflector
K. Auger
L. Auger compartment
M. Wheel
N. Lower blade
O. Transport handle
P. Lower part of handle
Q. Cable gland
R. Battery compartment
S. Battery charger (supplied separately)
T. Battery (supplied separately)
4. ASSEMBLY
For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
4.1 ASSEMBLY COMPONENTS
The packaging holds the components needed
for assembly (fig. 4 ) listed in the following table:
Component Fig. N.
Snow thrower 4 1
Discharge chute
adjustment handle
4.A, 4.A1,
4.A2
1
Handle 4.B 1
Handle fitting 4.C 1
Spacers and screws for
securing the handle in place
4.D, 4.E 2
Spacers and screws for
securing the handle in place
4.F, 4.G 4
Ignition key 4.H 1
Cable gland to handle 4.I 1
Deflector 4.J 1
Instructions - 1
4.2 UNPACKING
1. Cautiously open the packaging, paying
attention not to lose components.
2. Consult the documentation in the box,
including these instructions.
3. Remove all the unassembled parts from the
box.
4. Lift the snow thrower from the box.
5. Dispose of the box and packaging in
compliance with local regulations.
4.3 HANDLE ASSEMBLY
1. Assemble the central part of the handle
(fig. 4.C) on the snow thrower (lower part of
handle), fastening it with screws (fig. 4.D, 4.E)
on both sides.
2. Position the upper handle (fig. 4.B) on the
central one and fasten it with the specific
screws and fastenings (fig. 4.G, 4.F).
3. Fasten the electrical cable in place with the
specific cable gland (fig. 4.I).
4.4 DISCHARGE CHUTE ADJUSTMENT
HANDLE ASSEMBLY
1. Assemble the handle (fig. 5.A1) using the
specific extension shaft (fig. 5.A), fastening
it in place with the 2 screws (fig. 5.A2).Make
sure the holes of the shaft (fig. 5.A) and joint
(fig. 5.A1) are aligned.
2. Insert the 2 screws in the holes and fix.
3. Pass the handle obtained in the specific lower
handle support (fig. 5.B).
4. Insert the end of the handle in the specific
coupling hole on the chute, keeping it straight
and with the grip upwards (fig. 5.C).
5. Check the discharge chute by turning it
entirely in both directions. The chute must
freely rotate (fig. 9 ).
4.5 DEFLECTOR ASSEMBLY
1. Insert the deflector on the discharge duct in
the upright position (fig. 6.A).
2. Fit the tabs on both sides in the rotation
eyelets (fig. 6.B).
3. Push until the pins fit into the specific holes
with a click.
4.6 CABLE GLAND ASSEMBLY
Insert the cable in the cable gland
(fig. 4.I) and fit it on the intermediate handle.
5. CONTROLS
5.1 IGNITION KEY
Used to start and stop the motor. The
ignition key has two positions (fig. 8.H):
1. Key removed - OFF - the motor stops and
cannot be restarted.
2. Key inserted - ON - the motor can start and
run.