27
REPLACING THE GRINDING WHEEL
1. To replace the grinding wheel follow the steps for removing the grinding wheel (see
page 26). After the grinding wheel is removed, you need to remove the three flat-head
screws holding the drive plate adapter onto the diamond grinding wheel.
Note: When you purchase a replacement Grinding Wheel (Part # DSQ0500), it does not come
with the Drive Plate Adapter (Part # 801381) or Flat Head Screws (Part # 801382).
These parts need to be ordered separately or re-used if still in good condition.
2. Clean the inside of the Drive Plate Adapter and check for wear. If the square arbor is
worn, it will prevent the grinding wheel from floating on the flange nut, and should be
replaced.
3. Place the Drive Plate Adapter onto the new Diamond Grinding Wheel and align the
holes. A small drop of Loctite thread lock should be applied to each screw to keep it
from loosening. Tighten each screw until seated, then go back around and re-tighten
each screw to secure them evenly.
4. The new Diamond Grinding Wheel can now be reinstalled on the tool.
Grinding wheel, adapter and screws
Figure-27
Drive Plate
Adapter
Grinding Wheel
(26mm Arbor)
Flat Head Screws
(M4x6)
