10
GB
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
5.1 Dust extraction
5.1.1 Installing the dust bag (Figure 3/Item 11)
Slide the dust bag (11) on to the connection for the
dust extractor (5). Follow the instructions above in
reverse order to remove the dust bag.
The dust is extracted straight from the
sanding/grinding belt into the dust bag.
Important.
For health safety reasons it is
imperative that you use a dust bag.
5.2 Changing the sanding / grinding belt
(Fig. 4-5/Item 10)
Pull the clamping lever (9) to the outside to
relieve the tension in the sanding/grinding belt.
Pull the used sanding/grinding belt off the drive
rollers.
Slide the new sanding/grinding belt on to the
drive rollers.
Ensure that the direction of the sanding/grinding
belt (arrows on the inside of the sanding/grinding
belt) is identical to the direction of the belt
sander/grinder (arrow over the rear drive roller).
Press the clamping lever (9) to the rear to tension
the sanding/grinding belt.
5.3 Adjusting the position of the belt
(Fig. 6/Item 2)
Hold the belt sander/grinder with the
sanding/grinding plate at the top.
Switch on the belt sander/grinder.
By turning the setting screw (2) the belt position
should be set so that the sanding/grinding belt is
at the center of the two drive rollers.
6. Starting up
6.1 Switching ON/OFF (Fig. 7)
To switch on:
Press the ON/OFF switch (4).
Continuous operation:
Secure the switch (4) with the locking button (3).
To switch off:
Press the ON/OFF switch (4) briefly.
The machine can be operated on a temporary or
permanent setting.
6.2 Instructions for use
Important.
Never hold the workpiece you wish to
sand/grind in your hands. Secure the workpiece on a
sturdy surface or using a vise.
Allow the belt sander/grinder to start before you
place it on the workpiece.
Do not switch off the belt sander/grinder as long
as the sanding/grinding belt is in contact with the
workpiece.
Always hold the belt sander/grinder with both
hands whilst it is in use.
Always sand wood in the direction of the grain.
7. Replacing the power cable
If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
Anleitung_BBS_720_SPK7:_ 19.10.2009 13:15 Uhr Seite 10
