7
On the floor :
• Fix the two caster on each side
of the heater as shown.
• Fix the casters with screw.
On the wall :
• Mark first screw hole on the wall
(about 80 cm from floor).
• Drill first hole, then insert first screw anchor into the first hole with a hammer.
• Put mounting support on the wall and tighten lightly the first screw.
• Mark second hole on the wall by raising the support in parallel to the floor.
• Drill second screw into the second hole and the insert the screw anchor.
• Tighten both screws.
• Fix the feet cover.
• Place the mounting holes of the support at level of screws. Then the appliance is fixed.
• Plug the appliance.
• Turn the power switch (2) on desired position :
position I = 1000 W for model RET 1000
position I = 1000 W ou position II = 1500 W for model RET 1500
position I = 1200 W ou position II = 2000 W for model RET 2000
• Turn the thermostat (3) to select desired temperature.
• According to personnal needs, temperature can be increased or decreased with the thermostat.
• Anti-frost function keep the surrounding temperature above “freezing point”.
To do this, turn the thermostat until the mark.
In case of overheat, a safety device know as « thermal cut-off » has been installed within the
heater.
• Before any cleaning or maintenance operation, switch off and unplug the appliance.
Ensure it is perfectly cooled.
• To remove the dust, wipe your appliance with a cloth.
• Never use abrasives or detergents.
INSTALLATION
OPERATING INSTRUCTIONS
MAINTENANCE
RET 1000 notice: notice_PC461/462 17/09/07 12:25 Page 4
