I N S T
I N S T
A L L A
A L L A
T I O N
T I O N
On the floor :
• Fix the two caster frames (6) at each side
of the heater as shown in the following diagram.
• Chek the caster frames installation before using.
On the wall :
• Mark first screw hole on the wall (about one meter from floor).
• Drill first hole, then insert first screw anchor (12) into the first hole with a hammer.
• Put mounting support (10) on the wall and tighten lightly the first screw (11).
• Mark second screw hole on the wall by raising the support in
parallel to the floor. (at about 158 mm)
• Drill second screw into the second hole and then insert the screw anchor (12).
• Tighten both screws.
• Fix the cover feet
• Place the mounting holes of the support (9) at level of screws. Then the appliance is fixed.
M O D E
M O D E
3 RUNNING MODES :
“LOW” : it runs in low power for the desired time (never use this function without timer)
“HIGH” : it runs in high power for desired time (never use this function without timer)
“AUTO” : set the desired temperature from 7°C to 35°C. If the difference between room temperature and
desired temperature is
- more than 6°C, the appliance runs in high fan heater
- less than 6°C, the appliance runs in low fan heater
HIGH POWER
LOW POWER
PR3MBE 1500
1500 W
1000 W
PR3MBE 2000
2000 W
1300 W
O P E R A
O P E R A
T I N G I N S T R U C T I O N
T I N G I N S T R U C T I O N
PLUG THE APPLIANCE.
Turn the power switch to 1 position , as sound can be heard.
WITH REMOTE CONTROL OR CONTROL PANEL :
- Press MODE touch. The appliance starts in LOW mode (Its power is 1000 W for PR3MBE 1500 and
1300 W for PR3MBE 2000), the timer is set on 4 hours. To modify selected time, press + or – touch ( from
1 hour to 16 hours). If you select 0h, the appliance stops automatically a few seconds later.
LOW
22°C
TIME
4H
9
notice PR3MBE 28/03/07 15:58 Page 9
