Capacity @ 80°F/60%RH:
100 Pints Per Day
Capacity @ 73°F/60%RH:
78
PPD
Airflow :
250 CFM
Operating Temp. Range:
3
3.8
-105°F
Operating Relative Humidity Range:
36%-90%
COP:
2.7 L/kWh
Refrigerant:
R410A
Amperage Usage:
6.82 Amps
Power Supply:
115V/60Hz/Single Phase
Outlet Requirement:
15 Amp, 3
prong, GFCI
Sound Level:
60 dBa
Dimensions LxWxH:
13.8” x 15.8” x 23.7”
ETL Listed:
Yes
Specifications
How It Works
Installation Requirements
·
The area where the dehumidifier is located should be sealed with a vapor barrier.
• If the unit is installed in a crawl space, all vents should be sealed.
• For proper ventilation, neither the inlet or discharge should be positioned against a wall.
The inlet needs a minimum of 12” clearance and the discharge requires a minimum of 36”
clearance.
• For the best air diffusion, install the unit so that a side panel faces the wall.
• Alorair dehumidifiers are only intended for operation when the unit is upright and level
with the feet on the ground.
AlorAir dehumidifiers use an integrated humidistat to monitor theconditioned space. When
the relative humidity goes above the selected setpoint, the dehumidifier will energize. Air is
then drawn across an evaporator coil, which is cooler than the dew point of air. This means
moisture will condense out of the air. The air is then reheated through the condenser coil and
distributed back into the room.
3
Installation
1. Place dehumidifier on a level surface.
2. Set up the drain line
• Remove the compression nut and slide it over the end of the hose to be attached to unit.
• Slide the side of hose with compression nut over the insert on the compression fitting
completely.
• Tighten compression nut.
3. Plug dehumidifier into grounded 15 amp circuit.
• Do not place unit directly on vapor barrier. For example, use blocks or pavers to create a
level surface.
• If unit has been turned or flipped so that the compressor did not remain upright, place the
unit on a level surface and wait a minimum of 2 hours before proceeding.
Key Functions
1
.
Power
Key
·
Use this button to turn the dehumidifier on and off.
·
Press once to turn machine on. You will hear two beeps and the light will
illuminate green (solid or flashing depending on mode).
·
Press the power button a second time and you will hear one beep as the machine shuts
down. Note that there is a 1 minute fan delay.
2
.
Arrow
Buttons
·
Use
the
up
and
down
arrow
buttons
to
set
the
desired
humidity
setpoint
on
the
display
screen
.
·
The setpoint can be any number between 36%-90%. When the indoor humidity is higher
than the setpoint, the unit will operate.
• Keep in mind that the displayed humidity levels are approximate ( +/-5%)
3
.
Continuous
Mode
·
To set the unit to run continuously regardless of humidity, simply use the down
arrow key to set the humidity below 36%.
4
