Speedbike Standard :
The seat depth, footrest length and backrest angle can be adjusted very easy.
Just follow the steps below
Adjusting the footrest:
Loosen the footrest clamps
Then slide the footrest in the right position.
Make sure that the footrest is not too far out from the
main frame.
There should be aprox 5-6 cm left in the inside.
Fasten the clamps after adjusting.
Adjusting the crank width:
Open the headless screws a little bit and remove the end
cap.
Then you can remove the spacers and the crank arms.
Figure out the desired crank width.
Make sure the distance between the crank arm and
steering head is the same on every side.
Mount the endcaps and fasten the headless screw with a
max torque of 8Nm
Adjusting backrest angle:
You can lock the carbon fibre backrest in every position
you like.To adjust the backrest angle first unlock the quick
release by pulling the lever to the side.Once the backrest
clamp is opened you can bring the backrest in your desired
angle. If you found your chosen angle lock the quick release
lever again. Make sure the lever closes pretty solid.
Seat length adjustment:
You can change the seat length by unscrewing the backrest from the mainframe. Bring the backrest to your
desired position.
Then mount the backrest to the main frame again. Readjust the seating cover if necessary.
