STEP 1
- Locate the (3) bottom rails
and position as shown. Overlap the corner
joints and be sure the rails are square to
each other. Drill a 1/8” pilot hole in the
corner joints and secure rails to each other
using a single 5x70 screw in each of 3
corners.
STEP 2
- Locate the wood wall
elements (sections). These will be
inserted over the bottom rails as shown
in the diagram.
STEP 3
- Find the wall element with the square cut out
hole and position on the right rear of bottom rail. NOTE: If
the heater is going to be installed on the right wall then
positing the element with the square cut hole on the left
rear. (On all wall elements the
fl
at edge is the top and the
groove that will
fi
t over the tongue on the bottom rails is
on the bottom.) With one person holding this wall element
have another person position one of the 90° corner
posts and then another wall element section on the rail
perpendicular to the
fi
rst element section.
NOTE: It is helpful to tap the elements to each
other, to the corner piece, and to the bottom
rail using a rubber mallet.
Wall Element Sections
W=Wood
P=Post
G=Glass
D=Door
PW=Post Wider
