9
30. HEATER INSTALLATION
Mount the heater as shown in the instructions attached to the heater box. The heat-
er should be mounted on Wall Section E, over the vents and 7” from the floor of
the sauna. All necessary hardware is supplied with the heater.
Drill a hole below and behind the heater to run the wire and/or conduit according
to local electrical codes. The heater will be hard
-
wired according to its specific
wiring requirements.
Don’t attempt to wire the heater yourself. Contact a licensed electrician in accord-
ance with your local electrical codes. Heater brand may vary depending on where
sauna was purchased. Install sauna stones in accordance with heater manufacturer
instructions.
Typical wiring requirements for distances of up to 30 feet from the breaker box are as follows:
4.5kw
-
6.0kw heaters require 10
-
2 copper wire only, and 30amp non
-
GFCI breaker.
8.0kw 8
-
2 copper wire only, and 40amp non
-
GFCI breaker.
31. Your fence kit will arrive
banded with stretch wrap. It
consists of four pieces, shown
here.
32. Prop up the pre
-
assembled portion and attach the two long horizontal pieces. Make
sure that the countersunk holes on the wall mounting bracket face inward.
33. Attach the final piece—the remaining vertical fence post.
34. Position the fence around the heater and use the
pre
-
drilled holes to attach it to the wall.