almando Multiplay Stereo, Руководство пользователя, Страница: 15 / 20

15
General Settings
On this page you make general settings and have the possibility to reset the device to
the factory defaults or to update the firmware.
Here you determine whether data
signals will be sent to the B&O
speakers (input data from connected
B&O devices or data generated by the
almando Decoder itself for third-party
devices). This is only necessary if
BeoLab 5, BeoLab 4500 or BeoLab
Penta are connected. Otherwise the
generation of the "data signal" should
remain deactivated (default setting).
Usually a non-B&O device is connected to this input (INPUT 2) e.g. Sony TV, Sonos
Connect, etc., which is operated with automatic audio signal detction (then this switch
remains deactivated as in the delivery state).
If a device providing trigger voltage is connected to this input (e.g. a B&O system such
as BeoSound 9000, BeoSound Overture, etc.), you should activate this switch.
However, there are two exceptions: BeoSound Essence and BeoSound Moment - here
please leave this function deactivated, the input will then be operated with audio signal
detection.
Recommendation: if INPUT 2 is operated with signal detection (trigger voltage
INPUT 2 is not activated), set the gain to -10 dB in the input settings for INPUT 2 and
switch back to the main page of the app (control) so that this value remains permanently
stored.