ALM Pip Slope, Руководство по эксплуатации, Страница: 5 / 8

ALM-008 - ‘Pip Slope’
General Usage
A trigger or gate signal is patched into the top inputs of the module as to produce
an envelope (between 0 and ~+5v) at the output. The red LED indicates the output
level. A trigger input will produce an envelope that rises to ~5v and then instantly falls.
A gate input will rise and then stay high at ~5v whilst the gate is high before falling.
Note the attack (rising) phase is always completed - even if the gate finishes first.
The attack and decay times of the output envelope can be adjusted with the 2
relevant control knobs. Fully CW gives times of approx. 100 seconds whilst fully CCW
gives approx. sub 1ms times. The times can be further controlled by control signals
(0-5v response). With a control signal patched the control knobs become attenuation
controls on the input signal. They are not offsets.
The loop button provides toggling of automatic triggering and repeating (i.e looping)
of the envelope. The yellow LED indicates looping mode is enabled. A long (approx. 3
sec) hold of the loop button will toggle the envelope curve from exponential to linear
(and vise versa). The button release is then ignored (loop mode wont toggle).
The loop mode and curve type are retained across power cycles.
! 5