The body fat analyzer GBF-1719-A supports multiple users (Up to 8). You may follow
below instructions to assign User ID and set up your own profile, including Gender,
Stature, and Age.
Initial Start-Up
Initial Start-Up
Set Up Your Profile
Insert the Batteries
Transtek Body Fat Analyzer GBF-1719-A applies BIA (Bio-impedance Analysis)
technology. A small amount of weak current flows through the human body so as to detect
the bio-impedance and estimate BMI, body fat, body water, muscle mass and bone mass.
The electrical current is small and may not be felt.
This BIA technology is cheap, safe, non-invasive, toxic-free and harmless. It also
possesses the characteristics of simple operation and abundant information.
The current mentioned above is less than 0.5mA. However, please be aware that
anyone with an wearable or implantable medical electronic instrument, such as a
pacemaker, must avoid using this device.
The intended use of this device is for healthy children 10-17 years old and healthy
adults.
General Instructions
CAUTION
When the symbol “ ” appears, the device will power off in about 4s. Then you shall replace with a new
set of batteries. Please replace all four batteries at the same time. Do NOT mix the old batteries with the
new one.
Worn batteries are hazardous waste. Do NOT dispose of them together with the household garbage.
Please refer to the local ordinances and recycling instructions regarding disposal of the worn batteries
and scrapped device.
If you do not intend to use this unit for a prolonged period of time, it is advisable to remove the batteries
before storing.
Open the battery door in the back of the scale.
Remove insulating strip from beneath the battery (if
¿WWHGRULQVHUWEDWWHULHV
(3 x AAA) observing the polarity
signs (+ and -) inside the battery compartment.
* The digits “HI” will be shown on the LCD.
Close the battery door and wait until the digits “0.0lb” are
shown on the LCD.
After confirming User ID, the system will divert to Gender setting automatically.
As pictured below, the portrait blinks. The operator may press the function key
or to select Gender.( Male/Female/Male Athlete/Female Athlete)
Press “SET” key to confirm Gender.
With batteries correctly installed, press and hold “SET” key to enter setting mode
when the scale is on.
The system will request User ID selection first. As pictured below, “U1 0” blinks. The
operator may press the function key or to select User ID among U1 to U8. “0”
means that this user has not set up any profile.
Press “SET” key to confirm User ID.
After pressing “SET” key, the system will divert to clear previously data
automatically.(If the User ID has been set before) The operator may press the
function key or to select “y” or “N”. (Yes or No) The scale will turning off after
selecting “y”, then this user’s data will be clear when you turn on the scale again.
1.Assigning User ID
2.Setting Gender
Or
Athlete Mode:
An athlete is considered as a person who does 10 hours or more per week of aerobic activity
and has a resting heart rate of 60 beats perminute.These individuals should select Athlete
Mode for the most accurate measurement results.The body fat analyzer are not calibrated for
professional athletes or body builders.
