4
|
888-892-2213
|
alluserv.com
operatIon
The unit comes equipped with an adjustable thermostat
that is adjustable from
175
to
215˚
F. Once the tempera-
ture inside the cabinet is reached the preset thermostat
setting, the thermostat will cycle on and off to maintain
the preset temperature. The motor and fan will operate
continuously as long as the lighted “On-Off” switch is in
the “On” position.
Important:
The internal cabinet temperature will
vary. Once the internal temperature has stabilized, the in-
ternal temperature will be at the preset setting (
175
to
215˚
F.) at the thermostat sensing disc. However, internal
temperatures will vary within the heated compartment.
From a cold start, two (
2
) hours is recommended to heat
the plates to the proper temperature. If warm plates are
inserted for heating, allow one and one half (
1 ½
) hours
for the subsequent cycles.
To maintain proper operation, the lids must be kept
closed except when inserting or removing plates.
InstallatIon and start-up
1.
Carefully remove all external packaging material and
carefully roll the unit off of the wooden skid. If damage is
discovered, retain all packing materials and immediately
file a concealed shipping damage claim with the trans-
portation company.
2.
Remove all tape and protective coatings from the unit.
3.
Important:
Lift out the self leveling dispenser mech-
anisms and remove the corrugated packing materials
from the cabinet.
4.
Connect the unit to a proper electrical power source.
5.
Load the unit with plates. Since plates vary in height
and weight, the quantity will vary.
6.
Close the lids and turn the
“On-Off” switch “On”. When
the switch is on, the switch
will light up.
sprIng adjustment
dIspensIng mechanIsm
Important:
SPRIng ADjuSTMEnT IS nOT COV-
ERED unDER WARRAnTy!
The dispensing springs are preset for Alluserv bases. If
spring adjustments are required:
1.
cautIon:
Turn the unit off, open the lids and allow
for the internal temperature of the cabinet to cool down
to room temperature.
cautIon:
The bases will remain
hot for a long period of time. To remove them use heat
resistant gloves or a suction lifter. use insulated gloves to
remove plates.
2.
Open the lids, remove the lift out divider located be-
tween the dispensing mechanisms.
3.
Lift the dispensing mechanism out of the dispenser by
grasping the handles located on each side of the dis-
penser.
