Bedienungsanleitung
Operation manual
Notice d’utilisation
Instrucciones de servcio
Istruzioni per l’uso
www.alluris.de
Page 10 of 34
3.3. Selecting the operation mode
If the instrument is idle you can choose different modes of operation.
Selecting a specific operation mode you decide which values the
instrument shall display and the measuring frequency (instruments
series FMI-B10 and FMI-S10 have no Peak-option and high-speed-
measuring is not available).
Select the operation mode and the measuring frequency by pressing
the S-key.
3.3.1. Standard mode
In standard mode the actual measured value is displayed. By default
the display refresh rate is 10 Hz. In the settings menue P13 you may
change the refresh rate
(see p. 17 chapter 4.2.3 Display-refresh
.
3.3.2. Peak value detection with Peak modes
The peak modes allow to detect peak values.
In
Peak +
and
Peak –
mode the display works as a drag indicator,
that moves forward on increasing values. With temporarily decreasing
values the display remains unchanged.
N
Standard-Mode
Status: idle
Selecting operation modes
On / Off
S
S
S
S
h
Standard
N
Peak +
N
Peak
Peak -
N
Peak
Peak
N
Peak
Selecting the operation mode with the S-key (in series FMI-B10 und FMI-S10 the
Peak-option is not available)
