1. For your protection, wear protective safety glasses (Not provided).
2. Place the Pressure Washer near the working surface.
Make sure that the water source is turned on and all connections to
the Pressure Washer and Spray Gun are secure and without any water leakage.
The Pressure Washer motor runs
ONLY
when the
trigger is engaged.
3. Hold the gun securely with both hands. Point the
gun in a safe direction. Make sure that the gun safety
is unlocked and squeeze the trigger to allow any air
that is trapped inside the unit and hoses to escape.
Continue to squeeze the trigger until a steady stream
of water comes from the nozzle.
Make sure wand is SECURELY tightened to Gun. If the wand
is not securely locked into place, it could be ejected under high pressure when
operating the gun, possibly causing injury or damage.
4. Turn on the ON/Off switch on the front of the Pressure Washer.
NOTE:
Motor does not start until trigger is pulled.
5. Point the gun in a safe direction and squeeze the trigger to start
motor and water flow.
USAGE TIPS:
• To prevent damage to your surface and to select an
appropriate working pressure for your application,
always start with lowest pressure setting and
continue increasing the pressure until the best work
result is achieved.
• For most effective cleaning, keep spray nozzle from 8
to 24 inches away from cleaning surface.
• If you get spray nozzle too close, especially using
high pressure mode, you may damage surface being
cleaned.
• DO NOT get closer than 6 inches when cleaning tires.
14
UNLOCK
OFF
ON
