Alltech KEENAN MechFiber340, Руководство оператора

Страница: 8 / 76

4.3 FEEDING OUT
During mixing, the mixing chamber is separated from the feed out chamber by
a Variable Feed Control (VFC) or guillotine door, thus ensuring complete mixing.
The feed out chamber contains an auger which runs the entire length of the
machine.
When chopping/mixing is complete, the feed out tray should be set to the
required position, and the VFC door dropped, allowing the material to be swept
up by the paddles and pushed onto the auger – see figure 2. The VFC door
should be partially opened at first, ¼ ways, and when feed is seen discharging
then 15-20 seconds should be allowed before opening the VFC door fully. Door
position and ground speed should be set/used to allow an even feed out rate.
4.4 MAINTENANCE
CAUTION:
The VFC door should only be opened or closed when
the PTO is engaged (paddles turning) when material is
in the machine.
Figure 1: KEENAN MechFiber Mixer Wagon (BaleBlend Option Shown)
A properly operated and maintained KEENAN mixer wagon will give years of
trouble free operation. Regular maintenance of the machine is essential both
for long machine life and also to meet the warranty requirements. Refer
to instructions in maintenance section of this manual. Weekly cleaning of the
machine is recommended to prevent corrosion to the mixer body from old feed.
The level of cleaning required will depend on the material being mixed,
but any material which sits or lodges on the machine may both adversely
affect the operation of the machine and affect the quality of the mix if it
subsequently falls into the feeder during mixing. It is therefore essential
that routine cleaning and washing down of the feeder is completed.
8
Revision G04 July 2018