DISABLING OF THE SAFETY EDGE WHILE CLOSING
:
Procedure for setting the edge disabling point
1. Enter the programming mode by holding the MENU key and selecting the item In6
using the key SEL.
2. Set the parameter to on.
3. Make any other necessary settings and then exit the programming mode.
4. Bring the door to fully open position using the remote control or the button
connected to terminal L1.
5. Place a solid object (maximum height 5 cm) under the door so as to activate the
safety edge in the last section of the lowering phase.
6. Enable door closing (you can use the Start/Down control, depending on parameter
Lo1); the door hits the obstacle and starts opening again.
Visit our website: www.Alloremotecontrol.com