8
Follow the same procedure also for the other P keys
Meaning of the blinking LEDs:
1.
L2 on for 3 seconds: as soon as the receiver is powered.
2.
Brief flash of one led: when transmitting with a correctly memorised radio
control, and the respective relay is activated
3.
Simultaneous blinking of all the LEDs: during programming this indicates that a
transmitter that is already enabled is being memorized
4.
Alternate blinking of the LEDs: during programming this indicates that the
storage is full
ADVANCED PROGRAMMING:
The mode of operation may be changed in the receiver relay outputs, making them
versatile for various uses.
Attention! Do not set options given in this section with button P1 of the FOX SR
receiver
Single-step output
During programming press key P2 twice instead of once as described in paragraph 2
under the heading “Standard programming”
The led related to the pressed button gives 5 series of two blinks
During this stage, transmit with a transmitter
A fixed led light for a few moments indicates that memorisation has been successful.
The P2 output is now single-step. The output has no magnetic hold, so if - The led
related to the pressed button gives 5 series of two blinks. - During this stage, transmit
with a transmitter. - A fixed led light for a few moments indicates that memorisation
has been successful. The P2 output is now single-step. The output has no magnetic
hold, so if there is a power failure while the relay is activated, the latter deactivates
Timer output:
Press the key P2 3 times during programming
The led related to the pressed button gives 5 series of three blinks
Transmit with a remote control during this stage
A fixed led light for a few moments indicates that memorisation has been successful.
The P2 output has now become a timer
Visit our website: www.Alloremotecontrol.com
